Vertical jump calculator: your height from time in the air
Jump height = 9.81 × flight time² ÷ 8. Type your time in the air, or count the frames of a slow-motion video and divide by the frame rate, and this vertical jump calculator gives your height in cm and inches. Half a second in the air is 30.7 cm (12.1 in). Land the way you took off.
General information, not medical advice. Stop if you feel dizzy or unwell, and ask a professional about any health concern.
Your time in the air is your jump. Half a second up there is 30.7 cm, or 12.1 in. This calculator turns a flight time, typed or counted from a slow-motion video, into a height in centimetres and inches. Then it shows how much one frame more or less would move that number, so you know how far to trust the last digit.
Jump height
30.7cm
In inches
12.1in
Flight time
500ms
h = 9.81 × 0.500² / 8 = 0.307 m
One frame more or less, at 500 ms in the air
- 30fps+4.2 / −4.0 cm+1.7 / −1.6 in
- 60fps+2.1 / −2.0 cm+0.8 / −0.8 in
- 120fps+1.0 / −1.0 cm+0.4 / −0.4 in
- 240fps+0.5 / −0.5 cm+0.2 / −0.2 in
h = g × t² / 8 with g = 9.81 m/s². It assumes you land in the same position you took off in: legs long, toes first. A bent-knee landing stretches the flight time and the number reads high. Nothing you type leaves this page.
How to use it
- Pick your input. Type a flight time in seconds if a jump mat or a timer gave you one. Otherwise switch to video frames.
- Count the frames. Film in slow motion with the phone still and your feet in the shot. Step through frame by frame: count from the first frame with both feet off the floor to the first frame with a foot back down.
- Set the frame rate. Use the rate the video was filmed at, such as 120 or 240 fps. The playback speed does not matter.
- Read the height. You get centimetres, inches, the flight time in milliseconds and the sum written out.
The formula: h = g × t² / 8
You go up for half the flight and come down for the other half. A body falling for t/2 seconds drops g × (t/2)² / 2, which simplifies to g × t² / 8. With g = 9.81 m/s², height in metres is about 1.226 × t². This is the standard flight-time method behind jump mats and video timing (Bosco 1983), and it holds when your body is in the same position at take-off and at landing (Linthorne 2001).
No JavaScript? Here is the same formula worked out.
| Flight time | Height (cm) | Height (in) |
|---|---|---|
| 0.30 s | 11.0 | 4.3 |
| 0.35 s | 15.0 | 5.9 |
| 0.40 s | 19.6 | 7.7 |
| 0.45 s | 24.8 | 9.8 |
| 0.50 s | 30.7 | 12.1 |
| 0.55 s | 37.1 | 14.6 |
| 0.60 s | 44.1 | 17.4 |
| 0.65 s | 51.8 | 20.4 |
| 0.70 s | 60.1 | 23.7 |
| 0.75 s | 69.0 | 27.2 |
| 0.80 s | 78.5 | 30.9 |
Height grows with the square of the time. Add 0.1 s to a 0.5 s jump and the height climbs by 13.4 cm.
What one frame is worth
A video cuts time into slices. Miss the take-off or the landing by one frame and the flight time shifts by one slice. For a 0.50 s jump, from the same formula:
| Frame rate | One frame | One frame more | One frame less |
|---|---|---|---|
| 30 fps | 33.3 ms | +4.2 cm (+1.7 in) | −4.0 cm (−1.6 in) |
| 60 fps | 16.7 ms | +2.1 cm (+0.8 in) | −2.0 cm (−0.8 in) |
| 120 fps | 8.3 ms | +1.0 cm (+0.4 in) | −1.0 cm (−0.4 in) |
| 240 fps | 4.2 ms | +0.5 cm (+0.2 in) | −0.5 cm (−0.2 in) |
At 30 fps, a 2 cm "gain" between two jumps is smaller than one frame, so film at the highest rate your phone offers and count carefully.
Land the way you took off
The formula assumes the same body position at both ends of the flight. Land with bent knees or flat feet and you touch down lower than you left, which adds air time that is not jump height. In 27 people, flight time read 2.5 cm higher on average than take-off velocity, because the centre of mass was 5.3 cm lower at landing (Yamashita 2020). The fix is simple: toes first, legs long, then absorb.
One more limit: reach tests include the push up onto your toes as you leave the ground, while air time starts only once your feet are off. Reach numbers come out higher. To turn a vertical into a dunk number, use the dunk calculator and compare each method only with itself.
Skip the counting
Counting frames works, and it is slow. Vertical Jump does the timing for you: put the phone on the floor, back off until the frame turns green with all of you in it, and jump. The camera clocks your air time and converts it into a height. It also refuses a jump when you leave the frame, tuck your legs or land with bent knees, and says which one, so the next jump counts.
Questions
How do you calculate vertical jump from flight time?
Use h = g × t² / 8, with g = 9.81 m/s² and t in seconds. 0.50 s gives 9.81 × 0.25 / 8 = 0.307 m, so 30.7 cm or 12.1 in. The 8 comes from the physics: you rise for half the flight, and a fall over t/2 covers g × (t/2)² / 2.
How do I get my flight time from a video?
Film the jump in slow motion with your feet in the picture. Find the first frame with both feet off the floor and the first frame with a foot back down. Count the frames between them and divide by the rate the video was filmed at. 120 frames at 240 fps is 0.500 s.
What frame rate should I film at?
The higher the rate, the thinner each frame. At 0.50 s in the air, one frame moves the result by about 4 cm at 30 fps, 2 cm at 60 fps, 1 cm at 120 fps and 0.5 cm at 240 fps. The calculator shows it for your own jump.
Why does my jump read high?
Check the landing first. Bent knees or ankles at touchdown stretch the flight time. In 27 people, flight time read 2.5 cm higher on average than take-off velocity, because the body was 5.3 cm lower at landing. Land on your toes with your legs long.
Can I compare this with a wall-touch vertical?
Not directly. Reach tests include the push up onto your toes as you leave the ground. Air time starts only once your feet are off, so reach numbers come out higher. Compare each method only with itself, and use the dunk calculator for reach maths.
Should I swing my arms?
Swing or keep your hands on your hips, as long as you test the same way every time. Flight time measures the jump you actually do, so keep the same dip, the same arms and the same landing.
Does the calculator keep my jumps?
No. Your device does the sum, and the numbers are gone when you close the page.
Keep going
- The vertical jump test: a jump test you can repeat week after week.
- Average vertical jump: what the numbers in studies mean, and why your own baseline matters more.
- Stuck at the same vertical? What to change when the number stops moving.
- Find the jump you need for the rim with the dunk calculator.
Sources
- Linthorne (2001), Analysis of standing vertical jumps using a force platform, American Journal of Physics 69:1198
- Bosco, Luhtanen and Komi (1983), A simple method for measurement of mechanical power in jumping, European Journal of Applied Physiology 50:273-82
- Yamashita, Murata and Inaba (2020), Effect of Landing Posture on Jump Height Calculated from Flight Time, Applied Sciences 10:776
Made by EASYTECH, who also make Vertical Jump.
